🎒 SchoolNEW 💡 Suggest

Overhung (radial) load on the gearbox shaft (F = 2000·T·fz/d)

Radial load on the output shaft from a pinion, chain sprocket or pulley: F_R = 2000·T·fz/d, compared with the catalogue permitted load. An element on the shaft transmits torque with a tangential force F = 2·T / d; with T in N·m and d in mm this becomes F = 2000·T / d. The calculator is free and shows the formula, the working and a numerical example, with no sign-up.

Results

Indicative results: always verify with a qualified technician and the applicable standards. Legal notice

Step-by-step calculation with your values

    Formulas

    F_R = \frac{2000 \cdot T \cdot f_z}{d}
    u = \frac{F_R}{F_{RN}} \cdot 100

    How it is calculated

    An element on the shaft transmits torque with a tangential force F = 2·T / d; with T in N·m and d in mm this becomes F = 2000·T / d. The factor fz adds the belt or chain pre-tension: gear 1.15, chain 1.40, toothed belt 1.50, V-belt 1.75, flat belt 2.50 (typical catalogue values). The permitted load applies at mid-shaft: if the force acts further out, the manufacturer reduces it. Indicative values: the gearmotor manufacturer's data and instructions apply for the final selection.

    Results are indicative: for real projects and installations always check applicable standards and a qualified professional.

    Example

    With the values: Output torque T2 = 100 N·m; Pitch diameter of the element on the shaft = 100 mm; Transmission factor fz = Chain sprocket (≥ 20 teeth) · 1.40; Catalogue permitted radial load = 3,000 N — you get:

    • Radial (overhung) load F_R: 2,800 N
    • Use of the permitted load: 93.3 %

    Frequently asked questions

    Which formula does the “Overhung (radial) load on the gearbox shaft (F = 2000·T·fz/d)” calculator use?

    An element on the shaft transmits torque with a tangential force F = 2·T / d; with T in N·m and d in mm this becomes F = 2000·T / d. The factor fz adds the belt or chain pre-tension: gear 1.15, chain 1.40, toothed belt 1.50, V-belt 1.75, flat belt 2.50 (typical catalogue values). The permitted load applies at mid-shaft: if the force acts further out, the manufacturer reduces it. Indicative values: the gearmotor manufacturer's data and instructions apply for the final selection.

    Is FunConvert free?

    Yes. Every converter and calculator is free, with no sign-up and nothing to install. Calculations run in your browser.

    What do you think?

    Your rating